Electronics Forum | Fri Apr 30 07:39:54 EDT 2010 | jdengler
We do a similar part on a Fuji IP3. Set table speed to low. I do not know the QP, but if it's similar to the IP make sure the board clamp/unclamp is smooth. On our IP it got dirty and was jerking causing the board to jump a little which bounced ou
Electronics Forum | Wed May 05 15:27:06 EDT 2010 | bradlanger
Make sure that both lead frames are contacting the PCB pads when the part is on the placement head. We had an SM xfrmer that we were handling with vacuum by a ferrite cap that was not glued on straight. The part would contact one set of pads and get
Electronics Forum | Wed Sep 26 07:40:30 EDT 2012 | highmillr
I had this problem at another plant with the UP 2000....When the machine resets, The left and right side of the conveyor misaligns, causing the conveyor to be tight on the loading end and boards falling out of the unloading end. or vise versa...the t
Electronics Forum | Wed Sep 26 11:18:21 EDT 2012 | swag
You have to loosen the tension on both sides of the drive belt and skip a tooth or two until the cenveyor is parrallel. You'll have to grip the belt tight on one of the drive gears then force the other gear to rotate inside the belt on the other end
Electronics Forum | Wed Oct 27 19:50:59 EDT 1999 | chris
Hi What is the possible cause of non-wetting of solder paste to the gold land pad. What we observed in the surface of the non-wet pad is an organic FM, and using FTIR we found out that it is a flux. It is possible that the cause of non-wetting is
Electronics Forum | Thu Oct 28 09:25:35 EDT 1999 | Dave F
Chris: Typical non-wetting causes are: * Poorly controlled soldering process * Incorrect material * Surface contamination * Insufficient preheat * Misapplied solder mask * Shadowing Without intending to insult you, all of the causes of non-w
Electronics Forum | Sun Aug 01 11:34:06 EDT 2004 | Dhanish
Can Pick Up Misalignment or Bent Nozzle at Pick and Place Machine can cause missing or misalignment component?
Electronics Forum | Fri Sep 10 17:18:10 EDT 2010 | spitkis2
They may be misaligned so much so that self centering would not occur. How are you placing the micro BGA's? Depending on how the boards are transported onto the oven's conveyer, by the time they start to go through the oven, there could be additio
Electronics Forum | Thu Nov 04 21:36:36 EST 1999 | chris
Hi John, Thanks to your reply, just one question is it possible that the solder paste ( flux material )applied to the pads cause the non-wet. regards Chris
Electronics Forum | Fri Nov 05 10:01:04 EST 1999 | Dave F
Chris: You can have more than "one question!!!" Anyhow, yes crappy solder paste can cause non-wetting, but before you go there understand why the paste is wetting some surfaces, but not others. Ta Dave F
