Electronics Forum | Tue Nov 01 14:38:45 EDT 2022 | glasscake
Did the tray changer use to work on this machine? was it ever disabled and uncoupled from the machine? If you have an old data disk or backup disk of the machine try restoring to that. There is also a jumper inside the wiring harness to include the
Electronics Forum | Tue Nov 01 16:09:38 EDT 2022 | kamedatec
The machine had the Auto Tray installed but was removed to put here in the company because the machine was bigger than my elevator. The owner told me it was working, which made me waste time testing all possible settings, electronic cards and cables.
Electronics Forum | Fri Oct 28 02:18:03 EDT 2022 | kamedatec
I bought a YV100XG machine with AutoTC (Automatic Tray Feeder), Everything is working except AutoTC, when I active this function, pops up the error that the Servo Motor LZ1 was not found. I changed the control card of the servo motor, checked the wir
Electronics Forum | Sun Jul 15 20:10:09 EDT 2001 | Danial
What is the best method to repair Warped PCBA. Obviuosly twisting it back to make it flat would be a disasterous. The method that I've tried wold be mounting the assembled board to the flat holder with the clamp and bake them at 120 Deg C for about 4
Electronics Forum | Mon Jan 21 06:58:41 EST 2019 | kiransahu
Without PCB layout, not much would get done. It is a ubiquitous need across industries; Industrial, consumer, military...Everywhere you look, there are chips soldered to PCBs to create a final product for the end customer. But where did we all learn
Electronics Forum | Mon Dec 05 09:14:14 EST 2022 | peterm
Invoke. The PTF Setup Procedure dialog box displays. 4. Select Product. The Select Product File dialog box displays. 5. Select the same product used in the Open PTF Teach Product section above. 6. Enter the Slot number for the PTF and select Full
Electronics Forum | Tue Jul 07 10:25:03 EDT 2015 | swag
Dial indicator on a post/base. You might need a fine point tip to get between adjascent components and the BGA. Or... if you're real fance schmancy you could use a CMM if you have one.
Electronics Forum | Wed Oct 05 05:29:18 EDT 2016 | aurash
Anyone out there knows how to change the language on a MPAG3 machine? we got the machines in Japanese and we want to switch to english. Thanks in advance, Aurash
Electronics Forum | Mon Jul 01 09:33:08 EDT 2019 | dbuschel
if you can't change the PCB materials or design at this point, you might be able to reduce it somewhat through the use of fixtures or edge stiffeners. Unless it is a particularly thick board, I don't think the reflow profile would be the issue. The t
Electronics Forum | Mon Jul 16 21:44:07 EDT 2001 | davef
You�re correct. If you attach $5 to each board, your customer will be happy to approve your process change. Consider: �Process Improvement Strategies: Implementation Of A No-Clean Process" http://www.smta.org/knowledge/proceedings_abstract.cfm?PRO
