Electronics Forum | Tue Aug 25 16:35:36 EDT 2009 | drakealvarez
Universal G.S.M. single beam, head A1 (four spindle) -Aortiz
Electronics Forum | Sun Dec 25 18:13:33 EST 2005 | mika
Cheers for the info JAX, sounds like what I was > looking for. In the PTF You can have 2 matrix trays in the same feeder slot; one on the left side and one next to the other one; You don't need to mesaure the first pick-up location, distance from
Electronics Forum | Wed Dec 21 08:30:13 EST 2005 | jax
"aj" you should find your way to a training class. The measurement is from the zero point of the tray feeder( almost always the feeder slot pin giude that the center guide of the tray holder hits...located in the machine ). It is not the same as nest
Electronics Forum | Fri Nov 09 14:30:17 EST 2001 | vickt
FYI...Universal has software that "senses" if parts are present in the PTF trays or not. With some upgraded s/w your dumping would be over
Electronics Forum | Fri Aug 21 11:13:42 EDT 2009 | voytek
Hi, I am looking for Stationary Matrix Tray Feeder P/N 44976203. Thank you,
Electronics Forum | Wed Dec 21 04:00:38 EST 2005 | geb
I have a Universal GSM1. I'm trying to add a new 6*16 matrix feeder. Does anyone know what the pickup X & Y refers to in the Pickup Information section. I've looked at an 8*20 and it says x=-38.5 , y=-28.3, but its not clear where it expects zero to
Electronics Forum | Fri May 30 12:51:29 EDT 2003 | JB
I need info on loose pin vibratory feeders for Universal GSM. At this time we are presenting them in Matrix trays, and the cycle time is killing us. Any info on aftermarket Vibe feeder Companies would be great. Thanks JB
Electronics Forum | Mon Sep 25 11:19:23 EDT 2017 | swag
We've done some of this - paste in hole. O.K. success but really we prefer to do stuff on selective wave for best results. For your application, look at a high force head to place the snap in component. Additionally, you might find it more efficie
Electronics Forum | Tue May 01 16:36:12 EDT 2007 | ratsalad
I have been working with GSMs since 1999. Mostly, I've been programming them but for the past 2 1/2 years or so I've also gotten to know them mechanically. I think they are great machines. If you are looking at Flex head GSMs (4-spindle) they won'
Electronics Forum | Wed May 02 12:22:30 EDT 2007 | SWAG
Make sure you get a good upward looking camera combo. 4.0 on rear and 2.6 for PTF (platform tray feeder) parts is my favorite. Easy to wrench on, calibrate (if you have a cal. kit), and easy to program. Single beam will run at 2000+ cph and dual b
