Electronics Forum | Wed Apr 20 13:13:20 EDT 2016 | ttheis
Hi Guys, Yesterday one of our two gsm1 machines just stopped moving and let down the board mid-production. The epc computer continued to respond but no messages were displayed when palming up or down. I tried local IO and it said no IO was configure
Electronics Forum | Fri Mar 19 07:59:20 EST 1999 | Thomas Nocpen
Having been a FUJI line support engineer for years at my company, I was asked to evaluate the new Fuji feeders by our local Fuji rep. We have been using the Hover MPF feeder for the past 3 years and have had virtually no issues with them. The operato
Electronics Forum | Sat May 24 21:49:24 EDT 2003 | ramanandkini
We have an electronic circuit with a miniature stepper motor, quartz crystal, Electrolytic capacitor,chip resistors and few smt LEDs. The PCB material is CEM1 with SMOBC and HALS finish. This circuit is assembled in a plastic casing and goes in to a
Electronics Forum | Tue Jun 26 19:59:08 EDT 2001 | davef
They always tell you to calculate ROI, when they want to blow you off. Do a net search using - calculate ROI. Links to three pretty good descriptions on this are: http://www.dmreview.com/editorial/dmreview/print_action.cfm?EdID=2487 http://www.eval
Electronics Forum | Fri Jul 18 10:10:21 EDT 2014 | proceng1
We've got an MPM Accuflex printer that generally works great, but we've had a recurring problem. The powered rail (rear rail) fails to initialize. Sometimes all it takes is restarting the machine to get it to work. At the suggestion of the repair
Electronics Forum | Fri Nov 22 14:33:27 EST 2024 | carl_p
For the Conv direction. Depending on the software version your at - It should just be an option in within the on screen settings to set direction of travel or "ping pong"
Electronics Forum | Mon May 05 15:48:24 EDT 2025 | proceng1
We used to have 3 ACCUFLEX and a AP HiE. The APHIE would often have drivers fail. The biggest problem with ACCUFLEX was the leadscrews that control rail width would freeze up and fail initialization. If you can locate George Castanaguay, he is th
Electronics Forum | Thu Apr 18 17:00:05 EDT 2002 | JamesL
We do cleanliness testing each morning using a Zero Ion tester. Our pass/fail number is set at 37ug/square inch NaCl. We are rarely above 10ug/square inch NaCl. We use Aqueous flux. Our inline washer has a prewash (70psi@130 degrees F), wash (?psi),
Electronics Forum | Thu Apr 04 12:52:48 EDT 2019 | rodrigo
Hi, Our MCS30 had a bad backup battery in one of the boards. After changing the battery I got the all boot devices failed error. I managed to get a hold of some boot floppy disks and I can use disk1 to boot the MCS30 to a "$" prompt. I also have a di
Electronics Forum | Tue Nov 01 16:09:38 EDT 2022 | kamedatec
The machine had the Auto Tray installed but was removed to put here in the company because the machine was bigger than my elevator. The owner told me it was working, which made me waste time testing all possible settings, electronic cards and cables.
