quantities is safe and easy with the N100 Nibbler from FKN Systek. Blades are
available in standard thicknesses of .120”, .093” and .062”. Custom sizes to match the
width of the routed section can be ground. Tabs are cut cleanly on each side so that no
further clean up is required to remove excess material, as is often the case when using
hand tools or when breaking the panels manually. In addition, since only one tab is cut
at a time , minimal stress is imparted to the board during the process as the panel is
not pressed between two points during the cut.
The N100 is provided with a quick connect pneumatic port which plugs directly into
factory air (80-100 PSI). Stepping on a foot pedal activates the cutting process. The
excess material from the tab is stored inside a compartment of the tool and can be
easily removed at the convenience of the operator. To see a video of the N100 and
other depaneling methods go to fknsystek.com.
For more information find us on the internet at http://www.fknsystek.com or call
508 935 2282 - FKN Systek, Inc., Framingham, MA, USA.