Electronics Forum | Wed Oct 18 09:35:54 EDT 2000 | mike weekes
Does anyone know of a less expensive technique to monitor board cleanliness (chlorides in micrograms/in2) other than omega mater - ion chromatography is costing us an arm and a leg.
Electronics Forum | Wed Oct 18 16:33:26 EDT 2000 | Dave F
Mike: An omega meter has very little to do with ion chromatography. * IPC TM-650, 2.3.25B, Detection and Measurement of Ionizable Surface Contaminants is a process control method that washes boards with an isopropanol / water solution and measures
Electronics Forum | Sat Feb 14 08:21:13 EST 2009 | davef
We believe that it's perfectly resonable for you to define the cleanliness that you require. We recommend that you leave it at that and not define the process or materials that your supplier use in meeting that cleanliness level. Start with a dirty
Electronics Forum | Mon Feb 05 10:12:32 EST 2007 | slthomas
The use of booties isn't required per se, just considered a standard step necessary to reach the 10,000 target. You also need to vacuum (central vac system, NOT exhausting into the room) daily, mop weekly, have a one piece floor, blah, blah, blah....
Electronics Forum | Thu Oct 08 12:02:15 EDT 1998 | Bernardo Mendoza
I need to set a cleanliness limit for our incoming boards. I know that some people use 14-10 microgr. sq. in. But how can I determine what is best for me. Can anybody tell me if there's a standard for this. Right now we are using an Alpha Ionograph
Electronics Forum | Fri Oct 09 14:29:07 EDT 1998 | Chrys
| I need to set a cleanliness limit for our incoming boards. I know that some people use 14-10 microgr. sq. in. But how can I determine what is best for me. | Can anybody tell me if there's a standard for this. | Right now we are using an Alpha Iono
Electronics Forum | Fri Oct 09 23:17:05 EDT 1998 | kallol Chakraborty
| | I need to set a cleanliness limit for our incoming boards. I know that some people use 14-10 microgr. sq. in. But how can I determine what is best for me. | | Can anybody tell me if there's a standard for this. | | Right now we are using an Alph
Electronics Forum | Wed May 18 12:41:17 EDT 2005 | saragorcos
Hi there - Add us to your list - our laboratory provides SIR testing and offers advice on how to optimize cleanliness. Check out our website at http://www.residues.com - you can find more info and how to contact us there. Regards, Sara Gorcos For
Electronics Forum | Fri Jul 10 07:34:00 EDT 2020 | elijah
From the poor bonding strength of the board, the surface quality problems of the board are divided into: 1. The cleanliness of the board surface; 2. The problem of micro graphite (or surface energy) on the surface. PCB circuit board proofing Youke bo
Electronics Forum | Fri Aug 25 05:23:46 EDT 2000 | Wolfgang Busko
Hi Murad, like with many other questions it�s hard to judge without seeing the effect. Assuming that this site you�re talking about is well equiped with knowledge and that they handle their processes normally to everybody�s satisfaction it�s obvious
