Electrovert Omni 7 Views: 766

Electrovert Omni 7			seth	09/28/09
Electrovert Omni 7			Hussman	09/29/09
Electrovert Omni 7			SWAG	09/29/09
	Electrovert Omni 7		seth	09/29/09
		Electrovert Omni 7	seth	10/07/09

Email This Page to a Friend

Date: September 28, 2009 02:27 PM
Author: seth  
Subject: Electrovert Omni 7

I need help with conveyor speed in Omni Excel 7. It fluctuate, and never have a steady speed. I swapped the speed control card,calibrated, encoder, and I still have the same problem. Any help would be appreciated, thanks.

(http://www.smtnet.com/distributed_forums/Index.cfm?CFApp=8&Message_ID=60003)

---

Date: September 29, 2009 07:19 AM
Author: Hussman  
Subject: Electrovert Omni 7


Does it ramp up and dowm or do you get a jerk in the conveyor every so often? Jerk in the chain is a sticky link in the chain. Lube may work but if really bad needs replacement.

(http://www.smtnet.com/distributed_forums/Index.cfm?CFApp=8&Message_ID=60010)

---

Date: September 29, 2009 12:07 PM
Author: SWAG  
Subject: Electrovert Omni 7


The electronics degrade over time and you get troubles like you're having and you need to install a "noise reduction kit". Basically it's a new interface card set and some cables. You might call Speedline and ask tech. support if this is something you should try if you can't find any problems.

(http://www.smtnet.com/distributed_forums/Index.cfm?CFApp=8&Message_ID=60013)

---

Date: September 29, 2009 01:03 PM
Author: seth  
Subject: Electrovert Omni 7


Thank you for responding. I called Speedline tech support he think there is a short some where in the motor. I changed the motor out and still have the same problem. The chain is normal, and using automatic lubricating. I will check more into this, and will post if anything come up.

(http://www.smtnet.com/distributed_forums/Index.cfm?CFApp=8&Message_ID=60014)

---

Date: October 07, 2009 10:04 AM
Author: seth  
Subject: Electrovert Omni 7


> Thank you for responding. I called Speedline tech
> support he think there is a short some where in
> the motor. I changed the motor out and still have
> the same problem. The chain is normal, and using
> automatic lubricating. I will check more into
> this, and will post if anything come up.

Found the problem, faulty encoder or conveyor speed sensor.

(http://www.smtnet.com/distributed_forums/Index.cfm?CFApp=8&Message_ID=60061)