DJ-9000 DispenseJet Jet Technology
DJ-9000 DispenseJet Jet Technology
DJ-9000 DispenseJet Jet Technology Description:
This div will be replaced by the JW Player.
Jetting enables simultaneous underfill of top & bottom levels of Package-on-Package applications. Shown jetting with the DispenseJet DJ-9000.
Jetting is the best way to dispense many fluids quickly and accurately. The DJ-9000 has a high shot-generation rate, can be cleaned in a few minutes, and has fast changeover of wetted parts.
Speed, Flexibility, Process Control, Experience
Based on the award-winning DJ-2100 series, the DJ-9000 has a high shot-generation rate, can be cleaned in a few minutes, and has fast changeover of wetted parts.
Jetting offers many advantages over traditional needle dispensing to deliver speed, quality, and low cost of ownership.
- Speed: high flow rate up to 400 mg/second; high shot rate up to 200 dots per second; no Z-axis motion; jets "on the fly" - no stopping between dots required; less height sensing required; no needle backtracking to prevent fluid stringing.
- Quality: High wet-dispense accuracy; smaller wet-out areas; round, uniform dots;
improved line quality with no "dog-bones" and improved line knit.
- Avoid common problems: No bent needles; no chipped die; no dripping; reduced part interference; no effects from warpage; no corner buildup.
- Low Cost of Ownership: Easy and quick to clean in 10 minutes or less; maintenance is tool-free; less waste of fluid due to small wetted path; consumable parts are lower cost; no under-board support required.
You'll benefit from capabilities beyond traditional needle dispensing:
- Jets in tight spaces as small as 175 micrometers
- Small fillet sizes as small as 300 micrometers
- Dot diameter as small as 200 micrometers
- Shot volumes as small as 1.0 nanoliters
- Jet stream size as small as 50 µm
- Slim design increases dispense area.
- Jets fluids from 1 to 250,000 mPa (cps)
In operation, the jet "flies" over the part or substrate, and using a patented high-speed mechanism, shoots precise volumes of fluid in dots, lines and patterns. Jetting multiple shots in the same location creates larger dots. Lines and complex shapes are constructed from adjacent dots. Dispensing consistency is improved with active temperature controls.
With the Calibrated Process Jetting (CPJ) feature, volumetric repeatability can be maintained during long production runs to improve process capability (Cpk). Dispense patterns are programmed with a specified weight. CPJ periodically samples the dispense weight per shot, then computes the number of shots for each pattern. With this information, CPJ optimizes line speed based on maximum specified shot interval.
- Jets a wide range of fluids including underfill, SMA, encapsulants, conformal coating, UV adhesives and silver epoxy
- Fast - jetting eliminates z-axis motion
- Accurate - jetting is highly repeatable
- Easy to use and maintain
- Small wetted path so less fluid is wasted
- One model handles multiple applications
- Dot diameter as small as 200 micrometers (0.008 in.), compatible with typical 0402 components
- Surface Mount Technology (SMT)
- Chip Encapsulation
- No-flow Undefill
- Chip Scale Package
- Die Attach
- BGA Solder Ball Reinforcement
- Conductive Adhesive Dispensing
- Flat Panel Display Dispensing
DJ-9000 DispenseJet Jet Technology was added in May 2015
DJ-9000 DispenseJet Jet Technology has been viewed 2065 times