JUKI RX-6 High Speed Compact Modular Mounter

JUKI RX-6 High Speed Compact Modular Mounter Description:

Brand new modular mounter RX-6 combines high productivity, high flexibility and high quality using non-stop vision recognition and meets the demands of a wide range of components and boards.

Its replaceable head allows you to configure a production line that is best suited to your requirements.

• Compact footprint: the width is just 1.25 m
• Equipped with standard Placement Monitor check function. Further improvement of production quality.
• Replaceable heads allow you to configure a production line best suited to the current requirements.
• High-speed component placement using high-speed non-stop vision recognition
• Wide range of components and boards: tall components, large components and large boards.

Defective PWB Prevention & Rapid Analysis

An ultra miniature camera built into the head section captures images of component pick and placement in real time. An analysis is run for presence/absence and traceability information can be saved. This unique function prevents defective PWBs and reduces the time for root cause failure analysis.

Reduce errors due to solder paste alignment (Offset Placement After Solder Screen printing)

The OPASS function uses the machine's downward looking camera to check the location of solder paste vs. the pads and corrects the placement accordingly. This function reduces defects caused by misalignment of the paste on the pads.

Incorrect component prevention (Component Verification System - CVS)

By measuring the resistance, capacitance, or polarity before production starts, the machine can prevent incorrect components from being placed. The new CVS unit can check six components simultaneously, reducing the check and changeover times.

Machine construction for high-speed component placement and small-footprint design

High-speed component placement in a very compact footprint: 1.25 m wide Each machine is equipped with two heads, each with its own laser sensor. Components are centered in-flight between the pick and placement locations. Direct travel between the pick and placement position enables high speed placement with great accuracy.

Wide component range

The 6 nozzle head supports components from 01005 up to 33.5 x 33.5 mm and height up to 33 mm.
The 3 nozzle head supports an even wider variety: from 01005 chips up to 100 x 100 mm or 50 ×180 mm long connectors with height up to 33mm.
These heads are designed to handle a wide variety of components from ultra miniature resistors to large ICs or connectors.

Flexibility by changing the head unit

The rear head can be changed between a 6 nozzle head and a 3 nozzle head, giving greater flexibility to configure the production line to according to the current requirements.

Large PWB support

Board size up to 905 x 590 mm is standard. LED lights or LED back lights are easily handled with no special hardware.

JUKI is proud to offer laser centering technology for high speed, accurate placement.

The machine can recognize components of various shapes: from an ultra miniature components such as 0402 (01005) chips up to 33.5mm square components such as PLCCs, SOPs, BGAs, and QFPs. When the machine recognizes a component with laser, variations such as shape, color, and reflection do not matter.