SMT Equipment

FKN Systek K5000 - Multiple Blade Circular Blade PCB Depanelizer

Company Information:

Depanelizer Equipment and Tools For Electronic Assembly. PCB Racks and Trays. Wire Crimp Press and Tooling.

Millis, USA

Manufacturer

  • Phone 508 376 2500
  • Fax 508 376 2505

See Systek Website »

Company Postings:

(25) products in the catalog

(16) news releases

FKN Systek K5000 - Multiple Blade Circular Blade PCB Depanelizer

FKN Systek K5000 - Multiple Blade Circular Blade PCB Depanelizer

Name:

FKN Systek K5000 - Multiple Blade Circular Blade PCB Depanelizer

Category:

Depaneling

Offered by:

FKN Systek

View FKN Systek K5000 - Multiple Blade Circular Blade PCB Depanelizer

   

FKN Systek K5000 - Multiple Blade Circular Blade PCB Depanelizer Description:

FKN Systek K5000 - Multiple Blade Circular Blade PCB Depanelizer - Video Demonstration

FKN Systek K5000 - Manual board feed PCB multiple panel singulation

  • Singulate panels with up to 10 scorelines.
  • Singulate panels with components up to 2.5"
  • 3 models available:
    • - Output tray
    • - Straight output conveyor
    • - Right angle output conveyor

The K5000 PCB separator is designed to singulate a high volume of prescored multiple PCB sheets into individual units. For sheets with a width of up to 10.6" ( 270 mm), up to 10 circular blades simultaneously separate the PCBs into individual panels. To singulate the PCB panels, the sheet is laid onto the input conveyor and travels between the upper and lower row of circular blades.

As soon as the rotating blades grip the board, it is drawn into the machine and the panels are separated by pressure on the remaining material in the scoreline. A conveyor belt transports the separated panels out of the machine. These can then be removed by hand or continue on down the assembly line via conveyor.

During manual unloading, a light sensor at the end of the conveyor can detect if any panels have not been removed and stop the conveyor. The edge margin pieces pass underneath the sensor and drop into a container situated at the end of the conveyor belt.

The clearance between the upper and lower blades can be precisely adjusted by moving the upper drive shaft. The upper and lower blade sets are mounted on shafts which are held in a removable cartridge. To change blades for a different production run takes about 15 minutes. Remove and replace the blade holder cartridge with the new one. Reset the input conveyor for the new panel size and the machine is ready to singulate the next run.

Specifications

  • Cut panels to 12" wide.
  • Weight: 130 lbs (60 Kgs.)

K Series PCB Depanelizers

All of the K series depanelizers use the same principle of circular blade on circular blade or circular blade on linear blade operation to separate the panels by applying pressure along the remaining material of a scoreline. The blades for the K1000 to the K6000 are flat on one side, so boards with components up to the edge of the scoreline can be separated. The K7000  has extra thin blades for boards with very tight component spacing.

View FKN Systek K5000 - Multiple Blade Circular Blade PCB Depanelizer

FKN Systek K5000 - Multiple Blade Circular Blade PCB Depanelizer was added in Dec 2011

FKN Systek K5000 - Multiple Blade Circular Blade PCB Depanelizer has been viewed 2182 times

20 More Products from FKN Systek :

IPC Training & Certification - Blackfox

Global manufacturing solutions provider