Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


DYNAPERT DD4500 SETUP DIE NEEDED HELP!

Views: 2077


PFI

#38713

DYNAPERT DD4500 SETUP DIE NEEDED HELP! | 28 December, 2005

I direly need a Dynapert dd4500 setup jig if somoene has one they can sell or let me use for a fee so i can get one made at the machine shop, please let me know.

reply »

DannyJ

#38718

DYNAPERT DD4500 SETUP DIE NEEDED HELP! | 28 December, 2005

Do you need the 'bug' or the plate? The plate is what goes onto the table and the bug is what you put into the upper jaws...

We use the 4500 and I may be able to help you out. If you only need the bug, the width is .300" and I can get a measurement to you for the rest... I'm not sure the owner would go for releasing some of this tooling.

I also can give you part #'s, if that's what is needed.

Dan

reply »


PFI

#38728

DYNAPERT DD4500 SETUP DIE NEEDED HELP! | 29 December, 2005

I need the bug for the machine, if you could send me over the measurement i would try to get it made. would your owner consider releasing it if i gave him funds to secure its return and then paid him for the time i used it.

reply »


PFI

#38729

DYNAPERT DD4500 SETUP DIE NEEDED HELP! | 29 December, 2005

> I need the bug for the machine, if you could send > me over the measurement i would try to get it > made. would your owner consider releasing it if i > gave him funds to secure its return and then paid > him for the time i used it.

dan please send me the part number i will do some searching.

reply »

DannyJ

#38731

DYNAPERT DD4500 SETUP DIE NEEDED HELP! | 29 December, 2005

Hi PFI,

Sorry, the owner probably will not go for shipping the bug. We have 4 plates here, but only one bug for the dip and one for the VCD's. I'll do my best to get you the information needed, though...

The part # is DIP-561 and is $500 USD from Universal. I'll post the measurements if you wish to go that route instead in just a few moments.

Dan

reply »

DannyJ

#38732

DYNAPERT DD4500 SETUP DIE NEEDED HELP! | 29 December, 2005

Measurements: Block is .680" x .680" x .125" 4 dowel pins: .026" diameter x .250" length Center to center measurements on block where dowel pins are inserted: .600" x .600"

Let me know if I can be of any more assistance.

Dan

reply »

JOE

#38742

DYNAPERT DD4500 SETUP DIE NEEDED HELP! | 30 December, 2005

any chance i could trouble you for a picture to give to my machine shop.

reply »

DannyJ

#38768

DYNAPERT DD4500 SETUP DIE NEEDED HELP! | 3 January, 2006

Hi Joe,

Sorry for the delay, been off on holiday...

Just give me an email address and I'll forward one before the end of today. (Make sure to add something like removethis in the email, not sure if this list is crawled...)

Dan

reply »

JOE

#38831

DYNAPERT DD4500 SETUP DIE NEEDED HELP! | 5 January, 2006

Plasma Prior to Conformal Coating