Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


REBALLING MACHINE

Josue Jacquez

#4594

REBALLING MACHINE | 22 March, 2000

Is there some one who could recommend me a reballing Machine??

I'll appreciate your comments and if U have the web address for that machine.

Regards

reply »

Kal C.

#4595

Re: REBALLING MACHINE | 22 March, 2000

Hi Josue,

Check archives (I think 98-sept-Oct some vendor at SMTA Conf.)...I was looking for the same thing...was very skeptical about reliability data ..couldnt approve reballing process except protos. Low repeatability after DTC/stress.

Regards Kc.

reply »

Brian E. Steelglove

#4596

Re: REBALLING MACHINE | 27 March, 2000

Josue,

I know KME or Create makes a BP10 for BGA reballing and a BP20 for CSP. The only problem is that these machines are only used overseas so far.

Brian Steelglove

reply »

#4597

Re: REBALLING MACHINE | 27 March, 2000

Hepco has a re-balling machine that is very simple to use, and is a low cost equipment.

reply »

Aaron Unterborn

#4598

Re: REBALLING MACHINE | 28 March, 2000

The Hepco tool is nice but very manual. Need an automated solution? Look at the Vanguard VAi 6300 or the Speedline Matrixx. Both are considered industry standards. However, be prepared to spend big dollars.

reply »

PCB equipment

PCB Soldering Tools