Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Anyone with experience with new Juki machines?

Views: 1242

#37227

Anyone with experience with new Juki machines? | 19 October, 2005

Just wondering if anyone has any of the new/er Juki 2050, 2055, 2060 machines. They are saying they are very reliable and robust with the lowest cost of ownership? Any comments?

reply »

bobpan

#37228

Anyone with experience with new Juki machines? | 19 October, 2005

Doesn't every pick-n-place company trying to sell a machine say that?????

reply »

#37230

Anyone with experience with new Juki machines? | 19 October, 2005

Pretty sure, thats why I am here and not out on the floor trying to fix my new Juki...yet

reply »

bobpan

#37232

Anyone with experience with new Juki machines? | 19 October, 2005

hahhaaha....its robust and reliable.....you wont have to fix it......remember.......hahhahaha

reply »


FD

#37233

Anyone with experience with new Juki machines? | 19 October, 2005

There are not too many Juki users that are active on this forum.

I have been using them for over 10 years. Our company has had a variety of their machines as we have been upgrading over the years.

We haven't had any major issues. Clean it up and grease it a little. Replace a filter or two and the machine keeps running. Most of their models will run for years without any maintenance done to it at all.

reply »

Used PCB Equipment - AdoptSMT

SMT Machines