Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Mydata TP11

Views: 3777

vikkaraja

#36761

Mydata TP11 | 21 September, 2005

HI there,

I have a problem with my TP11 HYDRA HEAD. It is not picking up parts from the magazine. I have been working with Mydata on this issue, but I have not had much success so far. So far I done the followings:ran vaccum test, tube height, and Hydra tool offset. They all seem to be within spec. Thanks in advance.

reply »

chris

#36888

Mydata TP11 | 29 September, 2005

Have it been working earlier. Have you try to run it in stepper mode (ctrl s to start and ctrl e to exit)and look at the messages? That can be a good thing so you can analys if it goes down correctly or not.

reply »

#36889

Mydata TP11 | 29 September, 2005

Thanks for your reply. Now how do I accomplish that. Is it under TpSys service? Thanks

reply »

chris

#36910

Mydata TP11 | 30 September, 2005

Hi you can run it in normalmode it depends on which version of tpsys you have

reply »

#36915

Mydata TP11 | 30 September, 2005

Firmware version is 2.3.2d.

reply »

SMT Custom Nozzles

PCB Rework / Repair Services