Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Servo Alarm on FUJI IP-2 (MTU unit)

Views: 1637


ING

#36649

Servo Alarm on FUJI IP-2 (MTU unit) | 15 September, 2005

Hi,

this morning we got a "servo alarm MTU" on our FUJI IP-2. On a servopack, I see an " Over Current" error. what does it mean? I don't know hoe to check that. Can anyone help me?

Thanks a lot.

reply »

GAK

#36659

Servo Alarm on FUJI IP-2 (MTU unit) | 15 September, 2005

What kind of error code do you get?

Check your sensers my be bad.

reply »

#36660

Servo Alarm on FUJI IP-2 (MTU unit) | 15 September, 2005

Over Current means the motor is drawling too much current. Check for a jam on that axis, bad wire, bad motor, bad servo amp (yes the amp can go bad and make it appear that the motor is drawling too much current).

Jerry

reply »

GAK

#36664

Servo Alarm on FUJI IP-2 (MTU unit) | 15 September, 2005

If the end sensor is bad it will cause the axis to past it and travel against the end stop and cause an over current also. So it kind of depends on what the machine is trying to do.

reply »

ajay

#36676

Servo Alarm on FUJI IP-2 (MTU unit) | 16 September, 2005

check some relay might be bad on MTU. we faced similar problem in IP3.

reply »

vikkaraja

#36690

Servo Alarm on FUJI IP-2 (MTU unit) | 16 September, 2005

Most likely servo amp is bad.

reply »

SMT Custom Nozzles

Large PCB Dispensing System