Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


PCB Plating Thickness Meter???

Views: 1012

#36416

PCB Plating Thickness Meter??? | 30 August, 2005

Does any one knows where to get a plating thickness meter that can be use in the fine pitch contacts and trace in PCB application like BGA pads? If there's a hand held device at lower cost much better... Also if you can recommend companies that offer services in PCB plating thickness measurement. Thanks...

reply »

Slaine

#36425

PCB Plating Thickness Meter??? | 31 August, 2005

i looked at hand held XRFs for a similar application, but the smallest surface i could find one sampled was about 3mm diamiter and there about �30k but a few companies will lend you one dor trials, would tell you the plating thickness and metalic elements, you could try asking a plating house what they use?

reply »

cabs

#36504

PCB Plating Thickness Meter??? | 4 September, 2005

Thanks.... Can u direct me to a link or website of the companies that can perform this test???

reply »

Slaine

#36529

PCB Plating Thickness Meter??? | 7 September, 2005

lynn.shepherd@oxinst.co.uk is who i was dealing with, http://www.oxinst.co.uk/ANLPDP754.htm dont know if its exactly what you want but might point you in the right direction

reply »

cabs

#36530

PCB Plating Thickness Meter??? | 7 September, 2005

Thanks you so much for this information.... this will help a lot...

reply »

JTAG Live PCB Debug Software

Reflow Oven