Hello I am looking for a best solution to make a prototype of Single sided and double sided board. Using Orcad. The line / track width are 8/8 mil. the hole sizes are 0.6 0.8 , 1.2 and 2.6 mm. The size will be approx. 175 x 130mm. Could you please suggest me the best system . My future concern will be multilayer up to 6 layer. Thanks
Approaches are: * PCDATAK sells [through distributors and hobbist sites] inexpensive layout software and plastic sheets that you run through a copier and then use to image the traces on the bare board. Since you have the software, all you need is the plastic sheets. * LPKF [ http://www.lpkf.com ] provides a wide range of materials and equipment used in rapid prototyping.