Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Voltage linking and tip to ground resistance

Bruno Lalonde

#33924

Voltage linking and tip to ground resistance | 27 April, 2005

I m looking to implement a maintenance program here at Exfo, I'm looking form the norms on the hand soldering iron (tip to ground resistance and Voltage linking). Thank

This message was posted Add this forum to your site! Click to learn more. the Electronics Forum @

reply »

#33931

Voltage linking and tip to ground resistance | 27 April, 2005

Check with your soldering iron supplier. We'd expect them to say: * Tip to Ground Resistance: < 2 ohms, DC, with the unit turned on * Tip to Ground Potential: < 2 mV, true RMS, 50-500 Hz

Don't forget that could be some yammering about this in ANSI/ESD S20.20 - Protection of Electrical and Electronic Parts, Assemblies and Equipment (Excluding Electrically Initiated Explosive Devices)

reply »

Bruno Lalonde

#33951

Voltage linking and tip to ground resistance | 28 April, 2005

Thank for your quick answer, waht to you mean by yammering, I'm sorry my english is not very good

This message was posted Add this forum to your site! Click to learn more. the Electronics Forum @

reply »

#33956

Voltage linking and tip to ground resistance | 28 April, 2005

Don't apologize. Your English is fine. * In Enlish look here: http://www.freesearch.co.uk/dictionary/yammering

* In French, maybe: Parler � tort et � travers

reply »

Heller Industries Mark 5获得了 2015年中国SMT远见奖 - 回焊炉领域

ii-feed SMT Intelligent Feeder