Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Fuji CP troubleshooting

Mike B

#31906

Fuji CP troubleshooting | 5 January, 2005

We're getting an error on our CP643 that we can't seem to make sense of. It's a D1 axis error, but we're only getting it when we run a feeder on device 140. Any advice would be appreciated.

reply »

#31911

Fuji CP troubleshooting | 5 January, 2005

what size feeder are you using there, when does this alarm occur :during prod?

reply »

Johnw

#31963

Fuji CP troubleshooting | 10 January, 2005

you may have a servo reach pulse error go into mecha check and check zero dev

reply »

Johnw

#31964

Fuji CP troubleshooting | 10 January, 2005

just one other thing what system are you using ie f4g fujicam or flexer

reply »

ricardof

#31976

Fuji CP troubleshooting | 11 January, 2005

I guess it will be the size of the feeder on that position (Perhaps you're using a 12x8 or 16x8)

reply »

#32083

Fuji CP troubleshooting | 14 January, 2005

Device 70 and 140 must be an 8mm

reply »

#32115

Fuji CP troubleshooting | 17 January, 2005

Just a thought, but check to make sure you dont have a pickup offset in your pd or machine thats causeing your problem.

reply »

SMT Custom Nozzles

soldering station