Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Fuji IP3 Calibration


Don

#31518

Fuji IP3 Calibration | 29 November, 2004

Does anyone have instructions for calibration of a FUJI IP3?

I have all the jigs & software etc. but no instructions.

Any help would be appreciated, Thanks.

reply »

#31519

Fuji IP3 Calibration | 30 November, 2004

If you have never calibrated a Fuji IP machine before I would highly recommend getting Fuji, or an independent contractor to do this. Even with the instructions there are a few tricky parts.

reply »

vzsolt

#31525

Fuji IP3 Calibration | 30 November, 2004

I agree with jdengler. It is very hard if you never done before and for sure will not work 100% after.

reply »


Don

#31531

Fuji IP3 Calibration | 30 November, 2004

Thanks for the advice folks, but we only have one Fuji Engineer in Australia, and he is in Asia for training. I haven't looked at the machine yet, but am told it is misplacing small parts. It may only be the camera that needs calibrating, but I won't know till I get there and see for myself what is happening.

If instructions are available, I would really appreciate it if someone could send me a copy.

reply »

#31533

Fuji IP3 Calibration | 30 November, 2004

Contact Gerald Koh. He will get you the calibration manual. If you have been on Fuji calibration courses you will be ok. If not, forget it. Wait until Shing returns from overseas.

reply »


Don

#31534

Fuji IP3 Calibration | 30 November, 2004

Thanks for all the advice, I now have what I was looking for.

reply »

#36201

Fuji IP3 Calibration | 21 August, 2005

can you introduce us this engineer. We have many Fuji parts to sell to Australia.

B.rgds Eldon

reply »

#36204

Fuji IP3 Calibration | 22 August, 2005

Temporary you can solve by change in NC cordinate & diffenece in corrdinate should be equal to compoonent shift happening. ( Pl. make no change in fuducialc lines )

reply »

#36209

Fuji IP3 Calibration | 22 August, 2005

The only time I have seen any Fuji IP need calibration is if you have had a serious crash, or if an axis or camera has been removed. Make sure you don't have something else going on.

For instance check these things: 1.Check nozzle vacuum

2.Make sure all parts are off consistently...I.E. make sure its not a package or programming problem.

3.Replace camera bulbs

4.Make sure you have board supports installed.

5.Make sure board clamper is working properly.

reply »

SMT Custom Nozzles

StikNPeelâ„¢ Rework Stencils