Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Need to fix Universal programmer/digitizer

#31043

Need to fix Universal programmer/digitizer | 20 October, 2004

Hi,

I am looking for someone to repair my Universal Digitizer/Programmer model 6892. I can not get the "@" sign after loading the GEN.exe to UIC and also the X,Y display, over the digitizing table is blank. I think, there is a hardware issue.

Any recommendation on who could help to fix the problem will be greatly appreciated. I might also be looking for a regular maintenance service on our DIP Inserter and VCD Sequencer.

I am located West of Bostom, near Route 495

Thanks in advance,

Chez

P.S. - it is my first post on this forum.

reply »

M Cyr

#31178

Need to fix Universal programmer/digitizer | 1 November, 2004

Hi Chez,

If you are still in need of support, you may locate Universal support information at here: http://www.uic.com/wcms/WCMS2.nsf/index/Contact_Us_94.html You should start with IM technical support. Depending upon the assessment, they may recommend service support.

Best Regards,

Mike Cyr,

Global Services

reply »

#31179

Need to fix Universal programmer/digitizer | 1 November, 2004

Thanks Mike, Appreciate it Chez

reply »

PCB machines

Fluid Dispense Pump Integration