Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Universal Instruments PPU Transferring programs?

#30267

Universal Instruments PPU Transferring programs? | 27 August, 2004

Problem; when writing a program offline in notepad .txt importing to the PC is accepted transferring from PC to UICP is not excepted brings up program error. Viewing the program in the UICP what is excepted looks like this : 0001> 00000 00000 00000 00000 00000 00000 00000 X E Any Ideas what we are doing wrong?

reply »

#30269

Universal Instruments PPU Transferring programs? | 27 August, 2004

Looking in My book, it describes "E" in the last data field as follows. Load error. This function code is not programmed as part of a pattern step. The controller uses the E code as an error marker. While a pattern program is being loaded into memory,the controller checks the format of each pattern step. If an error is detected in a pattern step, the controller changes the function code of that step to an E. After the pattern is loaded, the controller displays the following message. {patern name} IN MEMORY ERROR DETECTED I would double check the whole program, all data fields. Also, I have been taught to make the first step in a program all zeros with D O in the 8 and 9 data fields for step and repeat. Hope this helps.

reply »

Tom B.

#30394

Universal Instruments PPU Transferring programs? | 6 September, 2004

Ensure that there is no space or extra characters at the end of the line. Use "END" key, if cursor does not stop directly behind you insert code, then that is most likely our problem.

I have found that MS-Dos Editor is better suited for PPU programs.

Tom

reply »

SMT Custom Nozzles

PCB machines