Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


QP341 vibra feeders

Mark

#29558

QP341 vibra feeders | 19 July, 2004

Ok, I went to Fuji one day for a show and asked a tech on why when I use my Vibra feeders I can't keep em running for the simple fact they don't advance fast enough for the QP picking sequence. So to let you all know (has helped alot) you go into the 1.) Unit 2.) Feeder type Change and set your timing on that particualr feeder to 70, 71, 72 if you go beyond than it delays it way to much. These are the only numbers I have used so up to you on using different ones but remember it will delay it hella lot if you go beyond 72. When you make a program change you have to go back and reset as well but I'm sure if you use the same slot you can probably change it at the machine for a default setting. Hope this help some people out cause it has helped some production on my side instead of the old reset start method.

reply »

Mark

#29559

QP341 vibra feeders | 19 July, 2004

stupid subject line......

reply »

ii-feed SMD Intelligent Feeder

SMT Machines china