Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
I need to purchase a rework tool mainly for QFP's including ...
- Mar 10, 2004
The Metcal will run you around $5,000.00. The Pace is over $...
- Mar 11, 2004
Rework station | 10 March, 2004
I need to purchase a rework tool mainly for QFP's including 30mm x 30mm. I was looking at a Metcal QX2 and a Pace TF200. I would welcome any comments on these two products or any other suggestions. Also, is a preheater necessary?
Rework station | 11 March, 2004
The Metcal will run you around $5,000.00. The Pace is over $6,000.00. Check out Hakko model 852/853 for under $2,000.00
If your in the NewEngland area call us we sell them also.
© 1995-2016 SMTnet
Who are SMTnet visitors?
Become a member now and receive the value and benefits of membership.