Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Contact Systems CS-400E Optical Correction

#27282

Contact Systems CS-400E Optical Correction | 16 February, 2004

Does anyone know how often the optical sensor goes bad on the CS-400E machines. I have 2 machines and it seems that the optical correction does not work anymore. I keep getting an optical correction error, when the mode is turned on the correction does not see the PTH and says to recenter. I was wondering if anyone else out there has had this problem or knowledge of the failure rate of these optical sensors.

Thanks,

Paul

reply »

Used PCB Equipment - AdoptSMT

PCB Rework / Repair Services