Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


LSM Cable


RDR

#26486

LSM Cable | 3 December, 2003

Does anybody out there know what type cable is used for the controller cable on an LSM large model circa 1996? Is it a standard 25 pin D-Sub? This is the cable that goes from the XY Axis line box to the controller. I have contacted Cyberoptics and they cannot help me since they no longer support this model. (I find it hard to believe that they can't tell me or find out what it is but Oh well)

thanks Russ

reply »

Dean

#26494

LSM Cable | 3 December, 2003

ohm out a sandard 25 pin d-sub. Make wire diagram. do the same to the lsm cable.

If same, use standard cable. If different, buy cable and solder lug d-sub connectors and make your own cable.

couple hours work.

reply »


RDR

#26495

LSM Cable | 3 December, 2003

thanks for the reply Dean, unfortunately I do not have this cable to compare it with. We bought the machine used and this cable was missing.

Russ

reply »

Dean

#26523

LSM Cable | 6 December, 2003

If this is an LSM1 or LSM 2 I have both of these. I can check the cables if you like and email you a wire diagram. I would bet dollars-to-donuts that it is a standard 25 pin parallel cable.

Let me know if your interested.

reply »


RDR

#26531

LSM Cable | 8 December, 2003

Dean, thanks again. I am going to but a standard cable and see if it works. If not I will ask for your help. I don't know if this is a 1 or 2 All I can find is "Large" for the model.

thanks again

Russ

reply »

PCB X-Ray Inspection

 Reflow System