Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


inline cleaner

honarar

#26074

inline cleaner | 16 October, 2003

We want to put an inline cleaner at the end of our reflow oven. should we be concerned about temp drop between the exit of the oven and inlet of the cleaner. does anyone know of a standard

reply »

honarar

#26075

inline cleaner | 16 October, 2003

We want to put an inline cleaner at the end of our reflow oven. should we be concerned about temp drop between the exit of the oven and inlet of the cleaner. does anyone know of a standard

reply »

Gabriele

#26087

inline cleaner | 16 October, 2003

Before entering the cleaner, the board should reach almost temperature of first pre-wash module (are you using DI water washing machine?), if water cleaner, normally the temp of prewash spry is set from 45 C� to 55 C�. (or it could be 10�C higher, but it depends if you want to save energy)

regards

This message was posted Add this forum to your site! Click to learn more. the Electronics Forum @

reply »

Gabriele

#26088

inline cleaner | 16 October, 2003

Before entering the cleaner, the board should reach almost temperature of first pre-wash module (are you using DI water washing machine?), if water cleaner, normally the temp of prewash spry is set from 45 C� to 55 C�. (or it could be 10�C higher, but it depends if you want to save energy)

regards

This message was posted Add this forum to your site! Click to learn more. the Electronics Forum @

reply »

Software for SMT

PCB Routers