Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


FUJI Error Code

#25155

FUJI Error Code | 14 July, 2003

Hello to all. I have problems with IP1 Fuji machine, the machine was working properly and suddenly appear the erroc code 000C error task 0028 and error address F92228A0, I turn off and On again, I erase the memory but I have the same prblem, I can not find this error on the machine manuals and I contact FujiAmerica but I don't have answer from them because they have to check with Japan, Any of you can help me to know what can I do, or where is the failure etc. etc... Best regards....

reply »

ServGuy

#25177

FUJI Error Code | 15 July, 2003

00c is a hardware interuption Addr F92228A0 is out of the card rack, meaning probably the CPU or memory PCB is out of control. Swap the 1st and or last card in the card rack with another machine or from spares.

reply »

#25178

FUJI Error Code | 15 July, 2003

I found the problem. The CPU is damaged I change the cards and it works..

Thanks and best Regards...

reply »

Stephen

#25187

FUJI Error Code | 16 July, 2003

You might want to check your input power. It is never "clean" but you might have too many spikes and transients. I've seen line monitors used and it was an eye opener how much noise there was on the input power. If you had a CPU go, you might want to consider a surge suppressor or something like that.

Stephen

reply »

SMT Custom Nozzles

Reflow Ovens thermal process improvement