Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Fuji MCS vs FujiCam vs UniCam

#20588

Fuji MCS vs FujiCam vs UniCam | 3 July, 2002

I am using the Fuji MCS computer and need to upgrade due to hard drive space limitations. Does anyone have any positive or negative feedback with using FujiCam or UniCam?

reply »

#20589

Fuji MCS vs FujiCam vs UniCam | 3 July, 2002

or with F4G?

reply »

mantis

#20593

Fuji MCS vs FujiCam vs UniCam | 3 July, 2002

We have used MCs F4g and fujicam,and i can definetly recommend going with fujicam.Its GUI is very easy to understand and generating programs couldnt be easier.Although it will probably take a little while to adjust from MCS.F4g was fuji's attempt at cam software and was a dissmal failure,it was far to slow and difficult to use.Reliasing there mistake they got unicam to develop there fujicam software as they had a proven record with cam.Id be suprised if u could get f4g now because as far as i am aware they dont sell it anymore they just support the companies who have it and havent gone to fujicam. Regards.

reply »

SMT Custom Nozzles

Metcal soldering rework