Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.

job setup


job setup | 9 April, 2002

I assume there are a variety of people that participate in this forum, i.e. contract manufacturers, OEM's, in a variety of job functions related to the production of surface mount boards. I have read about many concerns regarding the wrong part issue. There are about as many different setup/changeover processes as there are manufacturing facilities. Here's an opportunity for you all to vent a little. Can you tell me what your biggest issues/problems are with regards to SMT production (relative to job setup, kitting, pick and place, inventory control, etc.)? For example, is it a problem sometimes finding a particular part number when it is not in stock but on the production floor? Tell me what your issues are and if you have any ideas how to address them.

reply »

Alan W.


job setup | 10 April, 2002

Here are some of the problems (and my pet peeves) that can be found during a machine set-up. I have run into each of these many times over the years.

Wrong part value: This can usually be traced to a purchasing, incoming inspection, or kitting mistake. My favorite is when the part was put onto an old reel and the old numbers were left on. Always strip away old numbers or obliterate them.

Wrong Format: You programmed for tape and received the parts in tubes. Identifying specific formats for specific packages ahead of time for purchasing or whoever is supplying the parts is the best way to attack this. You may want all of your SOIC, TSOP and PLCC packages on tape. Or if you only do low volume you may always want them in tubes.

Tape with the leaders cut: Stockrooms are notorious for cutting the leader off tape to make counting of the material easier, or just cutting the tape into short pieces so they can issue exact counts. Of course then the tape needs to be stripped back or spliced to make it work on the feeder. In the past I have put up signs in the stock room- �Never Cut the Tape!�

Damaged Fine pitch parts in (or not in) Trays: Handling of FP parts in trays takes training for everyone who handles the parts. The machine operators and responsible engineers always seem to get the training, but not everyone else who handles the parts before and after. For moisture reasons the parts should stay in their original sealed package until the last possible moment before use. This will also have the desired affect of eliminating Pre-build damage. Of course there always seem to be parts left over, so they need to be properly secured in the correct (original) trays. My favorite is when FP parts are issued in bags.

Just a few issues. There are hundreds more.

This message was posted Add this forum to your site! Click to learn more. the Electronics Forum @

reply »


job setup | 17 April, 2002

So when you big guys have a reel of parts on one line and your only placing one part per board while on another line you need this reel (last one in the building) to place 30 parts per board, do you steal it and short it on the first line? How is this handled?

how are parts kept track of? Are they returned to stock to get rekitted or are they left on the floor untill their found?

reply »

Heller Industries Mark 5获得了 2015年中国SMT远见奖 - 回焊炉领域