Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Pierre Atchison

#16875

Placement of Tab Devices (C-Tabs) | 14 January, 1998

I am looking for equipment that can place and reflow c-tab devices. These devices are 0.012" pitch. Universal used to make a machine for this purpose, but it has been discontinued. If anyone has any info, please let me know. Thanks, Pierre Atchison pierre_atchison@nt.com

reply »

Chrys Shea

#16880

Re: Placement of Tab Devices (C-Tabs) | 15 January, 1998

:Too bad Universal's has been dicontinued. It was a great machine. Perhaps you can locate a second-hand one. ZevaTech made a TAB boonder as well. Have you contacted them? (I would recommend Univeral's, however).

reply »

Roger W Pufky

#16879

Re: Placement of Tab Devices (C-Tabs) | 15 January, 1998

| I am looking for equipment that can place and reflow c-tab devices. | These devices are 0.012" pitch. Universal used to make a machine for this purpose, but it has been discontinued. | If anyone has any info, please let me know. | Thanks, | Pierre Atchison | pierre_atchison@nt.com

reply »

Roger W Pufky

#16877

Re: Placement of Tab Devices (C-Tabs) | 15 January, 1998

| I am looking for equipment that can place and reflow c-tab devices. | These devices are 0.012" pitch. Universal used to make a machine for this purpose, but it has been discontinued. | If anyone has any info, please let me know. | Thanks, | Pierre Atchison | pierre_atchison@nt.com

reply »

Roger W Pufky

#16878

Re: Placement of Tab Devices (C-Tabs) | 15 January, 1998

hello, the person at Universal Instruments to contact about this machine is Mike Yingling at 607-7795899 or email yingling@uic.com , I have given him your e-mail address and a description of what you are looking for . rog | | I am looking for equipment that can place and reflow c-tab devices. | | These devices are 0.012" pitch. Universal used to make a machine for this purpose, but it has been discontinued. | | If anyone has any info, please let me know. | | Thanks, | | Pierre Atchison | | pierre_atchison@nt.com

reply »

Mike Moninger

#16876

Re: Placement of Tab Devices (C-Tabs) | 29 January, 1998

| I am looking for equipment that can place and reflow c-tab devices. | These devices are 0.012" pitch. Universal used to make a machine for this purpose, but it has been discontinued. | If anyone has any info, please let me know. | Thanks, | Pierre Atchison | pierre_atchison@nt.com SRT (Sierra Research) has a semi-automatic machine that will place and reflow this type of device. Good for low volume and rework. Try Microtek in Palm Bay, FL for the excise and form tooling.

reply »

ii-feed SMD Intelligent Feeder

Reflow Ovens thermal process improvement