Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Vanessa Munoz

#16819

SUPPLIERS SMT | 27 January, 1998

I am just implementing a Statistical Process Control to the SMD. A few simple questions: 1. Is it necessary to perform a sampling plan for suppliers inspection? 2. What are the basical points to control ourself and inspection at a supplier? I mean the regular inspection (solderability, warp...), not the evaluation of the supplier. I would appreciate any help Thanks

reply »

Vanessa

#16821

Re: SUPPLIERS SMT | 29 January, 1998

Still asking: does anybody know about any standards about transformers? material, tolerances, etc. thanks again

reply »

Mike C

#16820

Re: SUPPLIERS SMT | 30 January, 1998

| I am just implementing a Statistical Process Control to the SMD. | A few simple questions: | 1. Is it necessary to perform a sampling plan for suppliers inspection? | 2. What are the basical points to control ourself and inspection at a supplier? I mean the regular inspection (solderability, warp...), not the evaluation of the supplier. | I would appreciate any help | Thanks 1st consider the source of the components. New components from a OEM, generaly will not require inspection. On the other hand if you are recieving components from brokers, Tape and Reel house, or any unknown source then solderability and inspection (coplanaity, bend leads, and polarity) might be a good idea. Hope this help good day Mike

reply »

Yoshi

#16822

Re: SUPPLIERS SMT | 29 March, 1998

| | Still asking: | does anybody know about any standards about transformers? material, tolerances, etc. | thanks again I know just, http://www.orange.or.jp/~smt/home.htm for SMT equipment,and http://www.smema.com/ for standard.

reply »

Software for SMT

Solder Paste Inspection