Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Fuji Nozzle, in house repair?

Rob Cass

#16552

Fuji Nozzle, in house repair? | 12 March, 1998

Has anyone had any success in repairing Fuji CP nozzles in house? Removing bent press fitted nozzle and replacing. Any input would be appreciated, please no solicitation from repair shops

reply »

Rob Cass

#16553

Re: Fuji Nozzle, in house repair? | 12 March, 1998

| Has anyone had any success in repairing Fuji CP nozzles in house? Removing bent press fitted nozzle and replacing. Any input would be appreciated, please no solicitation from repair shops Rob, What model of CP?

reply »

Rob Cass

#16554

Re: Fuji Nozzle, in house repair? | 13 March, 1998

| | Has anyone had any success in repairing Fuji CP nozzles in house? Removing bent press fitted nozzle and replacing. Any input would be appreciated, please no solicitation from repair shops | Rob, | What model of CP? Mr. Kooki CP4 and 6 Mr. Kooki CP4 and 6

reply »

Phill Hunter

#16555

Re: Fuji Nozzle, in house repair? | 15 March, 1998

| | | Has anyone had any success in repairing Fuji CP nozzles in house? Removing bent press fitted nozzle and replacing. Any input would be appreciated, please no solicitation from repair shops | | Rob, | | What model of CP? | Mr. Kooki | CP4 and 6 | Mr. Kooki | CP4 and 6 CP4.3 nozzles are relatively cheap. How could your time (labor) be cost effective in replacing nozzle tips (consumable items)? I have two CP4.3 which ran for six months before bending a nozzle. If nozzle bending is freequent check your PD data and/or your station 1 and 7 adjustments as-well-as your Z-axis origin.

reply »

Ben Salisbury

#16556

Re: Fuji Nozzle, in house repair? | 10 April, 1998

| | | | Has anyone had any success in repairing Fuji CP nozzles in house? Removing bent press fitted nozzle and replacing. Any input would be appreciated, please no solicitation from repair shops So far I havn't had any luck in doing this...but then again, I've just toyed with it. Mr. Kooki was right in mentioning the labour costs. Another aspect to look at though if you are getting lots of bent nozzles, is your operators, We can run 2-3 months without damaging one. the number only tends to increase when we train new operators. Ben

reply »

PCB Soldering Tools

SMT Custom Nozzles