Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Sergio Luiz Vito

#14681

Insertion Optimization | 15 August, 1998

Hello, I am working in optimization of PANASERT MVIIF insertion programs and need some help. The result of PANAPRO HOST OPTIMIZATION is not too good - Sometimes assembly time after optimization is poor than original program (With no panapro host optimization). Is there something better than PANAPRO HOST OPTMIZATION to do this?

Thanks for the attention Eng. Sergio Luiz Vito Intelbras - Brazil

reply »

Lance A. Smalley

#14682

Re: Insertion Optimization | 22 August, 1998

Panapro Host Optimization should actually be very good. Make sure you're not using a fixed setup or the feeder carriage will move alot. Also make sure you do not change parts data in the machine after the program has been generated or speed of the head can make for a very slow running program. Programs can always be manually optimized better than computer optimized because of trade offs to conform to multiple users. But it is usually not worth the trouble unless you run lots and lots of a particular program. Good luck. | Hello, | I am working in optimization of PANASERT MVIIF insertion programs and need some help. | The result of PANAPRO HOST OPTIMIZATION is not too good - Sometimes assembly time after optimization is poor than original program (With no panapro host optimization). | Is there something better than | PANAPRO HOST OPTMIZATION to do this? | | Thanks for the attention | Eng. Sergio Luiz Vito | Intelbras - Brazil

reply »

reflow oven profiler

Used PCBA Equipment