Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Phil Teerink

#14275

NETCO Dip inserter | 14 September, 1998

I have an old Dip inserter that management would like to get running, as it has been sitting for about 5 yrs Not a problem, as it seems in good condition, but i have "inheirited" it from the previous tech, and no one seems to know how to run it or where the manuals are.... Was wondering if anyone knew of a company called North Eastern Tool Company ( NETCO ) and where I can reach them. A supplier or distrubutor would be be a good start too. Thanks in advance for any leads Phil Teerink Philt@pachena.ca 604-291-2025

reply »

Cunli Jia @ SMTnet

#14277

Re: NETCO Dip inserter | 14 September, 1998

Phil, Please call Rich Breault, president of NETCO Automation in Haverhill, Mass, at 978-372-7715. Hope it is the right company and please mention how you found it. Cunli

reply »

Dave F

#14276

Re: NETCO Dip inserter | 14 September, 1998

| I have an old Dip inserter that management would like to get running, as it has been sitting for about 5 yrs | Not a problem, as it seems in good condition, but i have "inheirited" it from the previous tech, and no one seems to know how to run it or where the manuals are.... | Was wondering if anyone knew of a company called North Eastern Tool Company ( NETCO ) and where I can reach them. | A supplier or distrubutor would be be a good start too. | Thanks in advance for any leads | Phil Teerink | Philt@pachena.ca | 604-291-2025 Phil: At previous plant, we had two Netco's. I remember them real positively. They were real easy to flip between jobs because to the carousels. Good luck Dave F

reply »

PCB equipment

ii-feed SMD Intelligent Feeder