Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


smd

#14122

Conductive Benchtops For Production/Inspection Areas | 24 September, 1998

Does anyone know where I can get conductive benchtops? NOTE: I don't want a mat and I'm already using (and unhappy with) a laminate surface glued to a wooden table. Any and all info would be very much appreciated. BTW: I'm also looking for conductive tubing that doesn't have wires inside. I want to cut 2" sections and slice them down the middle to put over power supply handles that are used with our switch products. The handles have an OD of 1/4" and are easily scratched.

reply »

Dave F

#14125

Re: Conductive Benchtops For Production/Inspection Areas | 24 September, 1998

| Does anyone know where I can get conductive benchtops? NOTE: I don't want a mat and I'm already using (and unhappy with) a laminate surface glued to a wooden table. Any and all info would be very much appreciated. | BTW: I'm also looking for conductive tubing that doesn't have wires inside. I want to cut 2" sections and slice them down the middle to put over power supply handles that are used with our switch products. The handles have an OD of 1/4" and are easily scratched. s: If you're looking for a hard laminate ESD material, like that material on some peoples' counter tops in their kitchen, I've got some sources for you. Antistatic Industries, 130 Gamewell St POBox 460 Hackensack, NJ 07602-0460 201.489.4400 fax 7654 Charles Water 617.821.8370 fax 575.0172 Kerstat 215.393.7290 fax7291 Jim Knight Plastic Systems 261 Cedar Hill St Marlboro MA 01752 508.485.7390 fax 800.505.5665 Nevamar 8339 Telegraph Rd Odenton MD 21113-1397 410.551.5000 fax 0341 On on the tubing, not the tubes packaging components, I can't help much except to say go try Antistatic Industries (above). Altho they have the component carrier tubes. These folks have unbelieveable ESD products ... ESD safe, FDA apptoved disposable hot cups; ESD safe elastic bands that will take 1000oF for 36 hours (why I need this, I don't know); silver ECM paints; and other stuff I can't figure-out ... Anyhow give them a try. TTYL Dave F

reply »

Wayne Bracy

#14124

Re: Conductive Benchtops For Production/Inspection Areas | 25 September, 1998

| Does anyone know where I can get conductive benchtops? NOTE: I don't want a mat and I'm already using (and unhappy with) a laminate surface glued to a wooden table. Any and all info would be very much appreciated. | BTW: I'm also looking for conductive tubing that doesn't have wires inside. I want to cut 2" sections and slice them down the middle to put over power supply handles that are used with our switch products. The handles have an OD of 1/4" and are easily scratched. SMD Check out GWS they manufacture a full line of ESD workstations including laminated tops. You can call Steve Castellani at (610) 366-7759. email address castellani7657@msn.com Sure Steve can direct you to the right person to speak with. Their website is www.gwsusa.com Wayne

reply »

smd

#14123

Re: Conductive Benchtops For Production/Inspection Areas | 25 September, 1998

Thanks for the sources, guys.

reply »

PCB X-Ray Inspection System

PCB X-Ray Inspection