Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Problem with a IP2 Machine Interface of FujiCam

#2505

Problem with a IP2 Machine Interface of FujiCam | 9 November, 2000

Somebody can help me with this problem.I already have installed the version of fujicam 1.2 but the machine interface that come with this don't work propertly this have a little problem with the rotation of theta is not the same with the theta assingned to another machine like a CP643.

If somebody have the installation program of the Ip2 most recently like a the version 39 11/8/99 product code: 1.1.1 CDLL Version 0.01

If somebody have the program please send me a copy of this to heimex@prodigy.net.mx

thanks for all. I really preciate your attention.

reply »

eva

#2506

Re: Problem with a IP2 Machine Interface of FujiCam | 9 November, 2000

Hello Omar, What software did you use before you installed FujiCam? What's the difference between theta for IP2 and CP6 ?

Regards, Eva

reply »

Al Lugo

#2507

Re: Problem with a IP2 Machine Interface of FujiCam | 9 November, 2000

Hi What you really need to do is call the software department at Fujiamerica (847.821.2401). They will review your process and get you back on track.

reply »

#2508

Re: Problem with a IP2 Machine Interface of FujiCam | 10 November, 2000

Hello Eva. I was using Fujicam 1.1 and i had a problem with the theta is in the shape library for example all the drawings are on 0 degress like a in the part data and all that work fine with the anothers machines like a cp6, but when i use a ip2 i must to change the theta of the shape 90 degress if i don't do that the part is reject.

I reacive the upgrade of fujicam 1.2 and i installed this and the machine interfaces for that version but was the same problem then i download the machine interface for fujicam programer's kit 1.2 program from Unicam.com and i installed this and all work very good i was using the same theta for all machines.

but the real problem come whit the computers where i have all the backups and the installation of that machine interface i lost them bacause the hard disk of the computers don't work any more.And i can't download because my year of update from unicam was expired. So i need the installation software for that machine again.

Thank's for listen to me. Best Reagards. Omar

reply »

Al Lugo

#2509

Re: Problem with a IP2 Machine Interface of FujiCam | 10 November, 2000

Hi Please call Fuji, I beleive that they can still help you.

reply »

SMT Machines

SMT Custom Nozzles