Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Guillermo Villegas

#13646

question about fuji ip3 machine | 29 October, 1998

Does anybody know how to update a different nozzle than the standard one on a Fuji IP3 machine?

I want to use a 15.8 mm height nozzle, but the limit on height size is 10 mm for IP3.I know, I need to use a special nozzle, so I�m trying with a 16.00 mm length, 6mm diameter and 102 mm backlight nozzle. I enter these values in proper data and part data but I can not transmit the program from MCS to the machine.

I�ll appreciatte your inputs.

Guillermo Villegas SMT Enginner Philips Consumer Comm. Guadalajara, Mexico

reply »

phillip hunter

#13647

Re: question about fuji ip3 machine | 30 October, 1998

| Does anybody know how to update a different nozzle than the standard one on a Fuji IP3 machine? | | I want to use a 15.8 mm height nozzle, but the limit on height size is 10 mm for IP3.I know, I need to use a special nozzle, so I�m trying with a 16.00 mm length, 6mm diameter and 102 mm backlight nozzle. | I enter these values in proper data and part data but I can not transmit the program from MCS to the machine. | | I�ll appreciatte your inputs. | | Guillermo Villegas | SMT Enginner | Philips Consumer Comm. | Guadalajara, Mexico | | My understanding is there are two nozzle length configurations available: 16 mm and 26 mm The proper probably needs to know what configuration you're using. It probably errors because you can't mix-n-match nozzle lengths (one size or the other) Where that is in proper I don't know. But Fuji America does. 1-847-913-0162 (ask for service dept) I run 26 mm nozzles lengths. When you find out, post a follow up.

reply »

SMT Custom Nozzles

PCB equipment