Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


0402 Component Placement

Jim Trent

#9614

0402 Component Placement | 14 September, 1999

Is it possible to place 0402 components with a Fuji CP2? How about a CP4? What are the suggestions for 0402 machine placement?

Any help would be appreciated.

reply »

Earl Moon

#9615

Re: 0402 Component Placement | 14 September, 1999

| Is it possible to place 0402 components with a Fuji CP2? How about a CP4? What are the suggestions for 0402 machine placement? | | Any help would be appreciated. | Never had a CP2. Had limited success on CP4's. Do better with 6's and some newer machines as Siplace and MYDATA.

Earl Moon

reply »

The Guc

#9616

Re: 0402 Component Placement | 14 September, 1999

| | Is it possible to place 0402 components with a Fuji CP2? How about a CP4? What are the suggestions for 0402 machine placement? | | | | Any help would be appreciated. | | | Never had a CP2. Had limited success on CP4's. Do better with 6's and some newer machines as Siplace and MYDATA. | | Earl Moon

| Try Amistar's Model 7100, PPH of about 18,000 and the best part..little set-up time,little programming effort and a pass through system.

reply »

#9617

Re: 0402 Component Placement | 14 September, 1999

| Is it possible to place 0402 components with a Fuji CP2? How about a CP4? What are the suggestions for 0402 machine placement? | | Any help would be appreciated. |

reply »

#9618

Re: 0402 Component Placement | 14 September, 1999

| | Is it possible to place 0402 components with a Fuji CP2? How about a CP4? What are the suggestions for 0402 machine placement? | | | | Any help would be appreciated.

According to the latest Fuji America S.M.T. Report I have, 0402 (1005) components can be placed with both the CP2 and CP4. The CP3, however, requires a special nozzle, feeder and firmware. You would need to use a .7 mm O.D. nozzle and a minimum 12 mm backlight disk. You may also want to reduce the Cam speed a little even though Fuji says it can be run at 100% for this type of part. Other than that, you shouldn't have any problems other than possibly a hard time seeing the little buggers. Good Luck!

reply »

KEVIN SIMPSON

#9619

Re: 0402 Component Placement | 14 September, 1999

| Is it possible to place 0402 components with a Fuji CP2? How about a CP4? What are the suggestions for 0402 machine placement? | | Any help would be appreciated. |

reply »

ii-feed SMD Intelligent Feeder

PCB X-Ray Inspection