Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


PCB failure analysis lab

Bob Smith

#8401

PCB failure analysis lab | 30 November, 1999

Hi,

Can anyone give me the name & address etc. of a lab that will section PCBs and analyze defects? Thanks.

Bob

reply »

#8402

Re: PCB failure analysis lab | 30 November, 1999

Where should this lab be, means where�s your place, you wouldn�t like to send your boards elsewhere on earth?

Wolfgang

reply »

Glenn Robertson

#8403

Re: PCB failure analysis lab | 30 November, 1999

Bob - Try John Maxwell at (719) 687-6911. I have seen him do some presentations at the trade shows.

Glenn Robertson

reply »

#8404

Re: PCB failure analysis lab | 30 November, 1999

Bob: consider two thing:

1 Most board fabs have PCB sectioning capabilities 2 Consultants Council Matrix (http://www.ipc.org/html/fsresources.htm) lists consultants that may be able to help you.

Ta

Dave F

reply »

dreamsniper

#8405

Re: PCB failure analysis lab | 5 December, 1999

Just contact any PCB fab near your area/country or wherever your manufacturing site is located and ask them if they could help you with your problems...they should be able to do that...

reply »

Manufacturing Software

SMT Equipment