Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Samsung CP45FV Neo

Views: 1073

#76449

Samsung CP45FV Neo swing mirror | 12 October, 2016

hello, I have a problem with CP45FV Neo swing mirror. The mirror it self works fine, manually controlled it moves to correct position and back. While working it also moves properly but when machine is about to check for nozzle existence at the end of program it remains open and machine is "unable to check nozzle existence". This is "resolved" by homing machine. Further more, it started failing dump operation. The mirror remains in open position while spindle runs down triggering EMER axis error. I tried setting up a backup system disk but problem remained. any ideas? thanks in advance.

reply »

#77207

Samsung CP45FV Neo swing mirror | 7 March, 2017

> hello, I have a problem with CP45FV Neo swing > mirror. The mirror it self works fine, manually > controlled it moves to correct position and back. > While working it also moves properly but when > machine is about to check for nozzle existence at > the end of program it remains open and machine is > "unable to check nozzle existence". This is > "resolved" by homing machine. Further more, it > started failing dump operation. The mirror > remains in open position while spindle runs down > triggering EMER axis error. I tried setting up > a backup system disk but problem remained. any > ideas? thanks in advance.

You can try calibrating the mirror positions.

reply »

#77210

Samsung CP45FV Neo swing mirror | 7 March, 2017

The mirror should stay open. go to sys setup go to head go t nozzle check settings. that is were the nozzle check is at

reply »

SMT Custom Nozzles

PCB equipment