Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Europlacer old style trolley adjustment

Views: 1984

#75397

Europlacer old style trolley adjustment | 29 February, 2016

When looking at 0402 parts in our old style Europlacer trolleys, the pick up point is in between two part slots. I have heard that there is a manual adjust somewhere on the sides of the trolley that will let you move part into the pick up window. I have not been able to find this adjustment location. Basically I am unable to move the package window low enough to match where the first part is showing in the trolley. any suggestions?

reply »

#75408

Europlacer old style trolley adjustment | 2 March, 2016

From what I can rememeber I used to set x & y to zero advance the tap ethen it was press the lane and vaild button together to advance half a pitch which should bring it all into line. All the older RC software you could just put a manual adjustment in the X pick up point (-2.5mm)but form 5.13 above that trck was taken out.

reply »

Boundary Scan

ii-feed SMD Intelligent Feeder