Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Samsung QSA error

Views: 1209

#74553

Samsung QSA error | 14 September, 2015

Upon start up our QSA machine is giving us the following errors.

Cant reset motor alarm (x axis) Cant reset motor alarm (y axis) Cant reset motor alarm (z axis)

What are the possible reasons for this? Thanks

reply »

#74572

Samsung QSA error | 18 September, 2015

Hello Simon, I would check to make sure the covers are closed and the cover switches are working. Make sure an e-stop is not pressed. After that....I would check the contactors in the rear of the machine. I have had the contacts on the insides of some of them open up after years of high voltage being switched on and off through them.

good luck Bob

reply »

SMT Custom Nozzles

SMT in-printer dispensing