Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


MYDATA M12

Views: 2340

#74198

MYDATA M12 | 10 July, 2015

good afternoon we have a M12 MYDATA gives us an error code (f-mot-move x / 143. position out of bounds, lower end) and can not initialize the hardware. If you can help please .... thank you ...

reply »

#74199

MYDATA M12 | 10 July, 2015

make sure noting stock in the X ,and motor brake work usually machine supply 24V to motor brake wire for release brake then move until hit the end stopper for init motor if brake keep on that will the error message

i got it often on the Z cause by lock coil become magnetized and pin not re-track before head move

reply »

#74200

MYDATA M12 | 10 July, 2015

> make sure noting stock in the X ,and motor brake > work usually machine supply 24V to motor brake > wire for release brake then move until hit the > end stopper for init motor if brake keep on > that will the error message > > i got it often > on the Z cause by lock coil become magnetized and > pin not re-track before head move

in our case the x if it moves and makes the whole journey, this detail when and maraca source is positioned at the error

reply »

#74201

MYDATA M12 | 10 July, 2015

in our case the x if it moves and makes the whole journey, this detail when positioned at source and mark the error

reply »

#74204

MYDATA M12 | 11 July, 2015

It sounds like perhaps and encoder issue. Call us at 813-880-8262 or visit our website http://www.islandsmt.com Perhaps we can help

reply »

SMT Custom Nozzles

SMT in-printer dispensing