Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


  • SMTnet
  • »
  • Electronics Forum
  • »
  • Can I apply IPC-610 class 3 workmanship standards to an assembly made with a IPC-600 class 2 PCB?

Can I apply IPC-610 class 3 workmanship standards to an assembly made with a IPC-600 class 2 PCB?

Views: 5566

#73457

Can I apply IPC-610 class 3 workmanship standards to an assembly made with a IPC-600 class 2 PCB? | 5 February, 2015

Can I apply IPC-610 class 3 workmanship standards to an assembly made with a IPC-600 class 2 PCB?

reply »

#73461

Can I apply IPC-610 class 3 workmanship standards to an assembly made with a IPC-600 class 2 PCB? | 6 February, 2015

I have asked that same question to a co-chair of the J-STD-001 committee who in turn checked with personnel at IPC. The answer I received is that yes you can apply the Class 3 assembly requirements using a class 2 PWB but the resultant assembly will be no greater than Class 2. If the customer requires Class 3 hardware then you must start with a Class 3 PWB. I hope that helps.

reply »

#73462

Can I apply IPC-610 class 3 workmanship standards to an assembly made with a IPC-600 class 2 PCB? | 6 February, 2015

Hi Scott,Thank you for the response. I was also thinking the same that the assembly will no longer be Class III. Thanks again.

reply »

  • SMTnet
  • »
  • Electronics Forum
  • »
  • Can I apply IPC-610 class 3 workmanship standards to an assembly made with a IPC-600 class 2 PCB?
Plasma Prior to Conformal Coating

Heller Industries Mark 5获得了 2015年中国SMT远见奖 - 回焊炉领域