Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Fuji CP3 teach fiducials mark or check part placement

Views: 3818

#73036

Fuji CP3 teach fiducials mark or check part placement | 8 November, 2014

Hello, Thanks help me to fix this CP3 and now it is running great. Do this machine CP3 has capability to teach fiducials mark and check placement part on the board?. I have the operating manual and program manual. but I can't not get the TEACH display on the machine nemu . In the manual show press PROGRAM > ETC then you see TEACH. But I can't see it. Do my machine need to update the software or chane some thing in the Proper program?. I'm using MCS16 computer. So far the machine runs great , But take me awhile to move to correct fiducial location Thank you

reply »

#73048

Fuji CP3 teach fiducials mark or check part placement | 10 November, 2014

Do you have the correct keyboard? Are all of the keys accurate for MCS?

reply »

#73051

Fuji CP3 teach fiducials mark or check part placement | 11 November, 2014

I do not recall that "TEACH" ever worked. Even if it did, there is no way to save this data to the MCS. After you see that a fiducial cannot be found, change Xa-Ya in the program at the MCS to find it, and of course, re-transmit.

Good Luck

reply »

#73053

Fuji CP3 teach fiducials mark or check part placement | 11 November, 2014

Thank you, that is help, I always change in program and re-transmit. One more question, I program N_data with capacitor is TANTB (using M nozzles in part data). but when I run the program in machine it is always use S nozzles to pick the cap. TANTB . Any ideal to correct this problem.

thank you Sony

reply »

#73062

Fuji CP3 teach fiducials mark or check part placement | 13 November, 2014

Are you using MCS1 or MCS2 software on the MCS16? For MCS1 I would have to try and remember, haven't seen that software in 20 years. For MCS2 in the PD make sure nozzle size, nozzle size min, and nozzle size max are all set to Med.

reply »

#73109

Fuji CP3 teach fiducials mark or check part placement | 18 November, 2014

THANK let me change in PD and see the result

reply »

#73112

Fuji CP3 teach fiducials mark or check part placement | 19 November, 2014

Oh yeah,

You can flip to switch on the camera card, VM1710 and jog the PCB under the fiducial camera to visually inspect to placements. switch it back when you are done.

reply »

SMT Custom Nozzles

ii-feed SMD Intelligent Feeder