Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


How is a Quad calibration slug?

Views: 2067

#72759

How is a Quad calibration slug? | 15 September, 2014

Hi evreybody I wish to know if somebody can describe how is made a "Calibration Slug" for centering the upward camera of a QUAD IVC machine. The instruction manual mentions a slug that is attached with vacuum to the "Vision Nozzle" and there is some kind of hole that must to be centered on the monitor's crossshair. I imagine that this piece is a species of polished metal dish or flat pan with a diameter of about 1/2". At the center perhaps there is a small blind hole (maybe 0,5 to 1mm diameter) which acts as a spot to center and focus the camera. How accurate is my imagination? Actually I prefer to hire a mechanician to machine the piece instead of import it. Thanks in advance Best regards

reply »

#72760

How is a Quad calibration slug? | 16 September, 2014

Please e-mail me @

www.precision-repairs.com and I can send you a drawing of the fixture you are looking for.

Bob

reply »

SMT Custom Nozzles

Metcal soldering rework