Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


IP3 NG Parts Discard Conveyor

Views: 1660

#72057

IP3 NG Parts Discard Conveyor | 2 May, 2014

We recived a used IP3 and don't have NG parts conveyor and I want to set the proper to discard component only in ng parts discard box.I think is in "Machine_ID" but I don't know how, we have Fuji Flexa sofware. any help?

reply »


tmo

#72059

IP3 NG Parts Discard Conveyor | 2 May, 2014

its being a while since I used the Flexa, but I remember there was an option for reject position where you can change from box to conveyor, but not sure if it was on the part or shape library, not on the machine_id.

reply »

#72060

IP3 NG Parts Discard Conveyor | 2 May, 2014

Give me 30 minutes.

reply »

#72063

IP3 NG Parts Discard Conveyor | 2 May, 2014

Bits 0-3, no, Bit 4, MFU2 with error parts conveyor for camera 12, Bit 5,MFU1 with error parts conveyor for camera 12. The other guy is also correct, where to discard a component is in the part data. Still checking, please reply quickly if you solve this.

reply »

#72064

IP3 NG Parts Discard Conveyor | 2 May, 2014

If the machine is throwing components at the "void" where the error should be, place a box. The standard rejection are quite small, large parts will not fit.

reply »

#72065

IP3 NG Parts Discard Conveyor | 2 May, 2014

You will have to open each parts Shape Data, Click on the Shape Process tab, Click on the Process tab, towards the bottom of the page under Error change the Dump Position to Box. This should work. Good luck.

reply »

PCB machines

PCB equipment