Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


siemens f5 software booting...

Views: 2126

#71857

siemens f5 software booting... | 24 March, 2014

siemens f5 software booting... on screen and nothing more

reply »

#71859

siemens f5 software booting... | 24 March, 2014

You could try reloading the MA data if you have a MA file backed up.

reply »

#71861

siemens f5 software booting... | 24 March, 2014

don`t have. give me please it. simens f5 with 6 segment head and IC-head. two conveyor. and if you can lower the entire inner hard drive, and then erased accidentally and slipped from siemens s27. thanks

reply »

#71868

siemens f5 software booting... | 25 March, 2014

Now it is the time to use your backups. If you don't have them you should probably reinstall your software and recalibrate your machine and .....next time you make sure you have backups.

reply »


tmo

#71874

siemens f5 software booting... | 25 March, 2014

Do you already check that the machine controller computer is booting?

reply »

#71877

siemens f5 software booting... | 25 March, 2014

machine controller BIOS loads only cyclically until pressed reset button on it - now checks the configuration and loading tasks load. hard drive I can take from the controller Siemens s27 example? motherboard came from s27 machine, and the same software? the upper computer program where Siemens f5 hm take? and after installation just spend a full calibration through sitest? full and had not passed was incorrect on DP axis always because of this constant errors were DP axis.

reply »

SMT Custom Nozzles

reflow oven profiler