Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Quad QSV-1 failed during production run

Views: 1472

#71693

Quad QSV-1 failed during production run | 9 February, 2014

Was running production when the head just came to a stop, motor went off, error window said to home.

Upon attempting to home, got message: G1T2 homing error; index mark not found.

I've tried rebooting the machine, but this error still appears.

Any ideas as to where to start troubleshooting?

reply »

#71727

Quad QSV-1 failed during production run | 15 February, 2014

This is a theta axis head 2 error. Manually spin the head and make sure the bearings are loose and spinning. If not, they may need lubricated or serviced. You can also swap theta amps between the heads to see if you have an amplifier problem.

Good Luck

reply »

#71764

Quad QSV-1 failed during production run | 24 February, 2014

Thanks Bobpan,

It was the theta amp; swapped it to the other side and that side then failed. It would only do it once the unit ran for about 30 minutes. But when it happened, it stayed broken. Swapped out with a refurb from ppm.

reply »

SMT Custom Nozzles

 Reflow System